Water Pump Short Impeller
This water pump has the by-pass hose take off. The pump was original equipment on the 803cc, and 948cc.
FITS:
       Morris Minor 1953 - 1962
FITS:
       Morris Minor 1953 - 1962
Water Pump with Large Impeller
These pumps have the same aluminum housing with the deep cast impeller and the by-pass hose take off. This higher capacity was original equipment on the 1098cc engines and more coolant then smaller impeller pumps on the 948 engines These water pumps have the much larger impeller, it sticks into the block very slightly more than 1/2"(14.03mm). This water pump will fit all 1098cc blocks and the small bore block 948cc.
FITS:
FITS:
- Morris Minor 1963-1971
- May be retro fitted to all earlier A-Series Engines for more capacity.Â
Super EVO Water Pump with Large Impeller
Fitted with a PPS, glass filled plastic impeller as used by Aston Martin and Jaguar it reduces weight on the bearing loading and has a triple lip seal giving a better controlled flow rate through the rev range.The pump is about 130 grams lighter and has the rolled edge gasket facing evolved for better sealing. Tested with coolant pumping at 10,000 rpm with no detriment to the PPS impeller this larger impeller pump moved more coolant than the original early standard pump.
The GWP134EVO has the by-pass hose take off. These water pumps have a much larger impeller, it sticks into the block very slightly more than 1/2"(14.03mm).
This water pump will fit all 1275cc blocks and all small bore blocks, with the exception of early 850/997cc units. These early blocks will need an amount of modification, relieving corrosion and slight material from the liner wall and impeller if required should enable clearance, try spinning pump loosely fitted without gasket for clearance. The high capacity water pump helps to reduce cavitation in the water jacket, particularly at high RPM, as well as circulating a greater volume of coolant. Further reduction of cavitation is achieved by using a large diameter water pump pulleys. When using a large diameter pulleyit is necessary to check clearance between the large pulley and the head, if a lot of material has been machined from the head face as it may foul the pulley function.
FITS:
- Morris Minor 1000
Water Pump Fitting Kit
Complete fixing kit for a water pump, includes replacement bypass hose, clips, superseal gasket, replacement bolts and washers. This kit designed for all pumpa with by-pass and dynamo lug.
FITS:
- Morris Minor 1955 - 1971
This Alloy water pump pulley is a direct replacement for the standard discontinued stamped steel, single belt water pump pulley used on all A-Series engines. Outside diameter is 98mm. These pulleys have a thicker front face, so if you currently have the 4mm spacer behind the fan, you will no longer need to use this.
Available in Black, Blue, Red via special order (allow 6 weeks).
FITS:
- Austin A35 1956 to 1959
- Austin A40 Farina 1958 to 1962
- Austin Healey Sprite 1958-1971
- Austin Mini & Cooper 'S' 1071 and 1275 1966 to 1980 (not A+)
- Austin America
- MG Midget 1962-1974
- Morris Minor 1000
Fan Belt
Factory style ribbed Fan Belt
FITS:
FITS:
- Morris Minor late 803cc & 948cc
Fan Belt
Factory style ribbed Fan Belt with Dynamo (generator)
FITS:
- Morris Minor 1963-1971
